18
Confidential
install the update. Repeat this for the flexstream-dsm-dsr-0.7.0.pkg file if you wish to also
update the RX-WP100 receiver units on your broadcast network.
a.
Hint: dsm = MX-GS200, dsr = RX-WP100
15
How do I re-order the channels in my channel map?
1)
The order to which minor channel numbers are assigned is the order in which they were
created. To set the order, delete all channels and add them in the order you wish them
assigned.
2)
Delete all input streams
by selecting the link at
the end of each input
defined. Be sure to
write down the port
and address
information so that you
can add it again.
3)
Add the inputs in the correct order using the “New Input”
button.
a.
Name the stream. This will be displayed on the RX-
WP100 OSD.
b.
IP Port assigned to the input stream.
c.
IP address, only used when receiving multicast streams.
d.
Interface. Select the interface on which the stream is
sourced.
16
What is managed mode and how do I use it?
The RX-WP100 receivers, and the display they are attached to, can be managed from the MX-GS200
WebUI. Use this feature to set the sub-channel that is tuned by the receiver, put the display (TV) in
standby mode, or set the display (TV) volume. Some display manufactures provide additional settings.
Each of these settings can be programmed to change state at any given time of day. The state can also
be forced to change immediately. For example, you can set channel 5.1 at 13:00, at 15:00 change the
channel to 5.3, and then at 19:00 change the channel to 5.2. Then, at 21:00, put the display into
standby state until 08:00 when it is turned on again.
Receivers are managed in groups. So the process to initiate this feature is to create a group, add a
receiver and place it in the group, and then schedule events for the group. Remember,
when a receiver
is managed some buttons on the receiver are disabled.
This is buy design to prevent tampering.
1)
Adding a group. Groups are defined on
the “Receiver Groups” tab. Select “New
Group” to add a group.
Summary of Contents for FlexStream MX-GS200
Page 5: ...5 Confidential Figure 1...