Wessamat Cube-Line IC 130 EL, User Manual, Page: 81 / 134

Operationg manual - English
Operating-Manual-CubeLine-v.01 01/2021
81
Network-
Power supply
230 V, 50 Hz
Residual water
connecion
Ø 20 mm
Defrostwater
connection
Ø 20 mm
Fresh
Water
connection
Ø ¾“
Fig.3: Rear view IC130 EL
Network-power
supply
230 V, 50 Hz
Fresh Water
connection
Ø ¾“
Defrostwater
connection-
Ø 20 mm
Residual
Water
connection
Ø 20 mm
Communication
socket 1
Communication
socket 2
Fig.4: Rear view IC135 ECL
5.2 Installation air cooled machine (Version L)
The following minimum clearances must be observed for air-cooled devices for safe operation
upward: 600 mm
– Side: 150 mm – Rearward: 150 mm.
When installing the air-cooled ice maker in small, closed rooms, sufficient air circulation (fresh air supply) must be
ensured.
The warm air produced by air-cooled models must be able to escape upwards unhindered, otherwise there is a risk
of an air short circuit. Do not cover the ventilation openings on the housing!
Please note the figures 3, 4 and 7!
5.2.1 Please connect the en
closed inlet hose (DN 8; ¾”–screwing) with the fresh water connection
Ø ¾“
and with the water tab (cold water-/ fresh water inlet). Make sure that the rubber sealing is well in place.
By IC130:
5.2.2 Fasten one drain hose (DN 20) to the residual
water connection of the machine, fix it with the hose
clamp and route it to the sewage network (see
chapter 5.4). Make sure that the hose always runs
with a slope and does not have any kinks.
5.2.3 Attach the other drain hose (DN 20) to the
machine's defrost water connection, fix it with the
hose clamp and route it to the waste water network
(see chapter 5.4). Make sure that the hose always
runs with a slope and does not have any kinks. If the
drain hose does not have a sufficient slope, the
storage container may overflow and water damage
may result.
By IC135:
5.2.2 Fasten the long drain hose (DN 20) to the
residual water connection on the machine and fix it
with the hose clamp.
5.2.3 Fasten the shorter hose section (DN 20) to the
Defrost water connection of the machine and fix it
with the hose clamp, attach the hose from the
residual water drain to the Residual water connection
and route to the waste water network (see chapter
5.4). Make sure that the hose always runs with a
slope and does not have any kinks. If the drain hose
does not have a sufficient slope, the storage
container may overflow and water damage may
result.