Weslo Pursuit E 28, User Manual

Page: 7 / 16

7
5. Attach the Seat (11) to the Seat Post (10) with four
M8 Nylon Locknuts (9) and four M8 Spring Washers
(8). Note: The Nylon Locknuts and Spring Washers
may be pre-attached to the Seat.
Press the Frame Bushing (4) into the Frame (1).
(Note: The Frame Bushing may be pre-assembled.)
Next, insert the Seat Post (10) into the Frame.
Align one of the holes in the Seat Post (10) with the
hole in the Frame (1). Insert the Seat Pin (31) into
the Frame and the Seat Post.
Make sure that the
Seat Pin is inserted into one of the holes in the
Seat Post; do not insert the Seat Pin under the
Seat Post.
Tighten the Seat Pin into the Frame.
8
11
1
Hole
8
31
9
9
10
22
49
6
20
44
46
47
6. Identify the Right Pedal (22), which is marked with
an “R” sticker. Remove only the Right Pedal Nut
(47) and the Pedal Bushing (46) from the Right
Pedal. Next, insert the shaft of the Right Pedal into
the right Pedal Arm (49). Slide the Pedal Bushing
onto the Right Pedal, and position the Pedal
Bushing so that it slides into the Pedal Arm. Tighten
the shaft of the Right Pedal
clockwise into the right
arm of the Crank (20) as firmly as possible. Then,
tighten the Pedal Nut
clockwise onto the Right
Pedal. Make sure that the Right Pedal and the
Pedal Nut are tightened as firmly as possible.
Repeat this step to attach the Left Pedal (not
shown), turning the Left Pedal and the Left Pedal
Nut (not shown)
counterclockwise .
7. Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some hard-
ware may be left over after assembly is completed.
Place a mat under the exercise cycle to protect the
floor or carpet from damage.
4
5