10
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
The exercise cycle can be cleaned with a soft, damp
cloth. Avoid spilling liquid on the console. Keep the
console out of direct sunlight or the display may be
damaged. Remove the battery when storing the exer-
cise cycle.
BATTERY REPLACEMENT
If the console does not function properly, the battery
should be replaced. See assembly step 4 on page 6.
In addition, make sure that the reed switch wire is
plugged fully into the console.
HOW TO TIGHTEN THE CRANK
If the arms of
the crank
become
loose, they
should be
tightened in
order to pre-
vent exces-
sive wear.
Loosen the
crank nut on
the left arm of
the crank.
Place the end of a standard screwdriver in one of the
slots in the slotted crank nut. Lightly tap the screwdriv-
er with a hammer to turn the slotted crank nut counter-
clockwise until the arms are no longer loose.
Do not
overtighten the slotted crank nut.
When the slotted
crank nut is properly tightened, retighten the crank
nut.
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedaling resistance when the
resistance knob is turned to the highest setting, the
resistance strap may need to be adjusted. To adjust
the resistance
strap, first turn
the resistance
knob counter-
clockwise to
the lowest set-
ting. Next,
locate the slot-
ted tab on the
front of the
exercise cycle.
Grip the
longest part the resistance strap underneath the slot-
ted tab and pull it towards the slot. When a little slack
is created, pull the end of the resistance strap tight.
Turn the crank for a moment to make sure that there
is not too much resistance.
HOW TO ADJUST THE CHAIN
The exercise cycle features a chain that must be kept
properly adjusted. If the chain causes excessive noise
or slips as you pedal, the chain should be adjusted.
To tighten the
chain, loosen,
but do not
remove, the
axle nuts on
both sides of
the flywheel.
Pull the fly-
wheel forward
slightly. Make
sure that the
flywheel is
straight and retighten the axle nuts.
MAINTENANCE AND TROUBLESHOOTING
Crank
Nut
Slotted
Crank
Nut
Crank Arm
Axle
Nut
Slotted
Tab
Resistance
Strap
Summary of Contents for Pursuit E 28
Page 13: ...13 NOTES ...
