Weslo Gym 1500, User Manual

Page: 8 / 27

8
7. Press a 25mm x 22mm Plastic Bushing (81) onto
each welded spacer on the Press Frame (6).
Slide the Press Frame into place on the Base (1).
Note: This will be a tight fit. The Plastic
Bushings should fit onto each end of the indi-
cated tube in the Base. Be sure that the cage
is on the side shown.
Lubricate the M10 x 195mm Bolt (75) with
grease. Attach the Press Frame (6) to the Base
(1) with the Bolt and an M10 Nylon Locknut (68).
Do not overtighten the Nylon Locknut; the
Press Frame must be able to pivot easily.
Press a 45mm Square Inner Cap (52) into the top
of a Press Arm (7). Press a 25mm Round Inner
Cap (74) into the outer end of the handle on the
Press Arm. Slide a Handgrip (31) onto the handle.
Attach the Press Arm (7) to one side of the Press
Frame (6) with two M8 x 63mm Bolts (69) and
two M8 Nylon Locknuts (58).
Assemble the other Press Arm (7) in the same
manner.
8. During steps 8 through 19, refer to the CABLE
DIAGRAM on page 17 of this manual to verify
proper cable routing.
Locate the Long Cable (47). Wrap the Long
Cable around a 90mm Pulley (44). Attach the
Pulley to the Top Frame (4) with an M10 x 90mm
Bolt (83), an M10 Washer (62), and an M10
Nylon Locknut (68).
Be sure that the Cable is
between the Pulley and the hook, and that the
end of the Cable with the ball is on the indi-
cated side of the hook.
9. Wrap the Long Cable (47) around a “V”-Pulley
(45). Attach the Pulley and a Long Cable Trap
(46) to the bracket on the side of the Upright (3)
with an M10 x 57mm Bolt (59) and an M10 Nylon
Locknut (68).
Be sure the Cable Trap is turned
to hold the Cable in the groove of the Pulley.
8
9
58
7
31
69
7
74
47
Hook
4
45
46
59
83
62
44
68
6
81
68
75
Tube
Lubricate
Cage
Welded Spacer
1
7
3
68
47
Cable Assembly
52