background image

This kettle has been designed to give you safe and 
efficient use and we would ask you to read all of these 
instructions carefully to ensure that you obtain the best 
results.

The new Terradur®-coating by Wesco

The Wesco Terradur®- waterkettle is made of high-quality 
steel and is coated on the outside as well as on the inside 
with Wesco Terradur®-coating. 
This is an eco-friendly functional coating based on natural 
inorganic raw materials. The extremely smooth surface is 
easy to clean, heat- and acid-resistant. The Wesco Terra-
dur®-coating is scratch-resistant, nickel-free and eco-fri-
endly due to its durability.

Safety instructions

It is recommended that you do not leave the kettle unat-
tended whilst heating. Please refrain from filling your 
kettle above the maximum water level (max. below spout). 
Please avoid boiling small amounts of water as this will 
cause the kettle to boil dry. In the unlikely event that the 
kettle has boiled dry, turn the heat off and allow to cool 
before handling. Don’t heat the kettle without water in it!

Handle, lid and whistle may become hot after prolonged 
heating. The use of oven gloves or a cloth is advised. 
Before placing the kettle on the hob, please ensure that 
the lid is pushed down firmly and that the whistle is posi-
tioned firmly on the spout. This will ensure that sufficient 
pressure is able to build up and cause a whistle at boiling 
point. Be cautious when removing the lid or the whistle 
immediately after boiling as the steam escaping from the 
kettle may hurt your hands. Remove the whistle laterally 
to avoid the escaping steam.

Before use

Ensure all labels and stickers are removed. Before first 
use, fill the kettle with cold water to the maximum filling 
level below the spout. Boil for two minutes. Allow to cool 
and empty the kettle. This procedure should be repeated 
two times. After that wash in warm soapy water, paying 
particular attention to the inside rim of the kettle body, 
lid, spout and whistle. Rinse and dry thoroughly.

CARE AND USE INSTRUCTIONS

WESCO TERRADUR

®

- WATERKETTLE

WESCO -  M. Westermann & Co. GmbH 

- Bahnhofstr. 205 - D-59759 Arnsberg

Tel. +49 (0) 29 32/4 76-0, Fax. +49 (0) 29 32/4 76-55 - [email protected] - www.wesco.de

04/2015

During use

Select heating ring to correspond with the size of the base 
of the kettle and place the kettle on center of the burner.
Please use medium flame resp. heat setting on every kind 
of hob (gas, electric, ceramic-top, induction). Do not use 
high temperature settings! On gas hobs make sure that the 
flames are not allowed to extend up the sides of the kettle. 
This might damage the plastic parts of the kettle.

As soon as the water is boiling (upon whistling tone) the 
kettle can be removed from the hob. Please wait 10 - 20 
seconds after boiling before pouring out the water. After 
the kettle has been used, allow it to cool before filling cold 
water in it. 

For cleaning the kettle we recommend dishwashing liquid 
and water, a dish-cloth or a non-abrasive sponge. Do not 
use abrasive cleaners. Rinse and dry thoroughly. Cleaning 
in the dishwasher is not recommended.

Mineral deposits in the kettle can be easily removed by fil-
ling the kettle half with water and adding the juice of half 
a lemon and two tablespoons of baking soda. Then boil the 
water for approx. 4 - 5 minutes. After that rinse and dry 
thoroughly.

If you comply with these care and use guidelines they will 
ensure that you enjoy successful and long lasting use of 
your kettle.

Reviews: