LIMITED WARRANTY
WESCO INDUSTRIAL PRODUCTS (WESCO) warrants to the purchaser of this product for a period of ninety (90) days from the date of purchase that this product shall be free of
defects in material and/or workmanship, as follows:
1. WESCO will supply, at no charge, new or rebuilt replacements for any part that fails through a defect in material and/or workmanship during the warranty period. To obtain warranty
service, you must deliver the product prepaid, to the WESCO factory.
2. This warranty does not cover any product or product part which has been subject to accident, misuse, abuse or negligence. WESCO shall only be liable under this warranty if the
product is used the manner intended by the manufacturer as specified in the written instructions furnished with this product.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. ANY EXPRESS WARRANTY NOT PROVIDED IN
THIS WARRANTY DOCUMENT, AND ANY REMEDY FOR BREACH OF CONTRACT THAT, BUT FOR THIS PROVISION, MIGHT ARISE BY IMPLICATION OR OPERATION OF LAW,
IS HEREBY EXCLUDED AND DISCLAIMED. UNDER NO CIRCUMSTANCES SHALL WESCO BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY, EXPRESS OR IMPLIED, A BREACH OF CONTRACT OR OTHERWISE. EXCEPT TO THE
EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR PURPOSE ARE EXPRESSLY LIMITED
IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
Some states do not allow the exclusion or limitation of incidental or consequential damages, or allow limitations on how long any implied warranty lasts, so the above limitations may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Operation Instructions
The following outlines the general operation of Fork Mounted
Drum Grabs. Specifics for different models are followed by
the general steps.
(1) Place unit on floor or flat surface easily accessible to
fork truck. Be sure that “T” bolts are sufficiently
unthreaded to allow forks to enter pockets.
(2) Carefully slide forks (do not use fork extensions) into
drum grab’s fork pockets. Be sure forks are in pockets
as far as possible.
(3) Hand tighten “T” bolts to secure unit to forks (hand tool
may be used but is not necessary). Recheck bolts
periodically during use for tightness.
(4) If not already done, unfold grab jaws
(5) Raise unit and approach drum so that the jaws come in
contact with the drum just below the upper rolling rib of
the drum. (Figure 2)
Figure 2
(6) Move unit forward onto drum, lowering jaws slowly as
you move. Jaws will open and close around drum.
(Figure 3)
Figure 3
Fork Mounted Drum Grabs: DJ-55, DJL-55,
DJ-255, ADJ-53, ADJL-53, ADJ-253
(Part #’s 240048, 270051, 240049, 240047, 270084, 240066)
Operating Instructions and Parts Manual
ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR WESCO DRUM
GRAB, READ THESE INSTRUCTIONS BEFORE USING.
Operation Instructions (Continued)
(7) When jaws surround drum, raise forks until jaws rest
under rolling rib. Drum can now be raised and moved
where desired.
(8) To release drums, return to floor lowering drum grab
slowly as you pull back.
Model DJ-255
Follow same procedure with two drums at same time. For
easier pickup, drums should touch each other. Be sure that
drum weights are similar to insure balanced load.
Model ADJ-53 & ADJL-53 (Adjustable)
Operation is same as general instructions except jaws must
be properly positioned for 55 or 30 gallon drums:
-
55 Gallon Drum: Both jaws to the outside and in lower
position.
-
30 Gallon Drum: Both jaws to the inside and in upper
position.
Jaws are positioned by raising to 90 degrees and sliding up
or down shaft. For upper position, hold jaw in position when
lowering to insure catching stop rod.
Model ADJ-253 (Adjustable)
Follow jaw positioning instructions for ADJ-53. Placement for
55 gallon drums is the same as DJ-255. 30 gallon drums
should be placed approximately 11.5 cm apart, and center
bar should be folded down between jaws. Follow use
instructions for DJ-255.
Maintenance
-
Lubricate moving parts periodically.
Industrial Products, Inc.
