WESAUDIO
4/10/20
NGLEVELER USER MANUAL REV2
30
and channel Y IN of ngLEVELER should receive signal from the OUT of
device.
3.
THD - toggles THD level, possible steps – OFF (LEDs disabled), MED, HIGH.
4.
SOLO/MUTE – Solo and Mute for particular channel.
5.
IN metering – signal level for particular channel measured after PAD, however
before ngLEVELER main circuit (Leveling, THD, Solo, Mute).
6.
Fader - Level control.
7.
OUT metering - signal level for particular channel measured after ngLEVELER
main circuit.
8.
Channel name – assignable and fully user configurable channel name – please
note that this name will be also communicated to external controller if in use.
9.
PAD – Passive 6dB attenuator.
7.1.3.
Plug-in – automation of linked channels
Please note that when channels are linked together using LINK or LINK OPPOSITE
modes, only one channel needs to be automated and second channel will follow
accordingly. If both channels will be automated, each channel will try to update the
other one, which will definitely lead to unexpected and unwanted results.
For STEREO mode, second channel changes are always ignored, so even if we
would have automation lane written for CH2, CH1 will always take control upon both
channels in analog domain.
Summary of Contents for ngLEVELER
