57
2D-/3D Profile Sensors
7.11 Password
Password protection prevents inadvertent changes to selected settings.
Password
Activating the password function
Enable/Disable
Change
3
Back
7
Run
Enable/
Disable:
Change:
Enable or disable password protection. When password
protection is enabled, the sensor is automatically disabled after
pressing any key in the “Run” mode.
Change the password.
NOTE!
• If the password function has been activated, the password must be entered each time
supply power is interrupted. After pressing any key, the menu is automatically switched
to the password entry mode.
• After the password has been correctly entered, the entire menu is enabled and the
sensor can be operated. The password function is deactivated upon shipment from the
factory.
Passwords can be selected within a range of
0000 to 9999.
• It must be assured that the selected password is noted before any changes occur.
If the password is forgotten, it has to be overwritten with a master password.
The master password can be requested by e-mail from
8. Maintenance Instructions
NOTE!
• This wenglor sensor is maintenance-free.
• Cleaning of both lens covers at regular intervals is recommended in order to assure
uniform good quality of the measured values. A commercially available cloth for cleaning
eyeglasses can be used for this purpose.
• Do not clean the sensor with solvents or cleansers which could damage the product.
9. Proper Disposal
wenglor sensoric GmbH does not accept the return of unusable or irreparable products. Respectively valid
national waste disposal regulations apply to product disposal.