Wenglor ODX402P0088, Operating Instructions Manual

Page: 14 / 23

14 Settings
6.2.4 Reset
Function Description
Reset Default setting
All of the selected Sensor settings are returned
to their default values by pressing the R key.
6.3. Output
In the menu Outputs the 13 outputs of the Sensor are configured and linked.
Therefor select one of the 13 outputs, or all outputs (Global) with the navigation keys and the enter key.
The output(s) then can be configured and linked.
6.3.1 Configuring the Output
Function Description
PNP/NPN Selecting the Output Type
The output is preset to PNP. Pressing the
6
key sets the output to push-
pull. Pressing the
6
key again sets the output to NPN.
The respective circuit diagram indicates how the output is set:
PNP Push-Pull NPN
Note: NPN possible only for outputs 2 – 13.
NO/NC Selecting the Output Function
The normally open or normally closed output function is selected by
pressing the NO or the NC key. The respective circuit diagram is dis-
played.
On-Delay Adjusting On-Delay
On-delay can be adjusted within a range of 0 to 10000 ms by pressing
the + or – key.* See figure 4 on page 16.