Refer to Recommended Maintenance Schedule in Fig. 9 for maintaining the spark plug.
The spark plug is important for proper engine operation. Check the spark plug regularly for proper engine
operation. A good spark plug should be intact, free of deposits, and properly gapped.
SPARK PLUG MAINTENANCE
MAINTENANCE
To inspect or replace the spark plug:
1. Pull on the spark plug boot to remove it. Be careful not to tear
any insulation or wire.
2. Use the included spark plug wrench to unscrew and carefully
remove the spark plug from the engine.
3. Visually inspect the spark plug. If it is cracked or chipped, or if
the electrodes are worn or burned, discard it and replace with a
new spark plug.
We recommend replacing with a NGK BP5ES spark plug (Part No.
56105-069), available for purchase at wenproducts.com.
4. If re-using the spark plug, use a wire brush to clean any dirt
from around the spark plug base, then re-gap the spark plug.
5. Measure the plug gap with a spark plug gap gauge. The gap
should be 0.7 to 0.8 mm (0.028-0.031 in.) (Fig. 14). Carefully
adjust the gap if necessary.
6. Screw the spark plug back into the spark plug hole by hand.
After the spark plug is properly seated, use the spark plug
wrench to tighten it. Do not over-tighten the spark plug.
NOTE:
The spark plug torque is 9 - 12 N.m ( 7 - 8 ft.lb). The
spark plug should be tightened 1/2 to 3/4 turn after spark plug
gasket contacts spark plug hole.
7. Reinstall the spark plug boot over the spark plug.
Recommended Spark Plug:
NGK BP5ES, Torch F5TC or Similar
1
20
Fig. 13
Fig. 14
Summary of Contents for 56105
Page 25: ...WIRING DIAGRAM 25 ...
