5
Static IP
DHCP Client (RFC 2131) at WAN port
PPPoE at WAN port
DNS Client at WAN port
TCP/UDP (RFC 793/768)
RTP/RTCP (RFC 1889/1890)
IPV4 ICMP (RFC 792)/IPV6 ICMP (RFC 4443)
TFTP Client
VOIP VLAN Support (802.1q/802.1p)
HTTP/HTTPS Server
QoS Support
Support IPV4 only, IPV6 only or dual stack mode
1-3 Front Panel: LED Indicators
Figure 1-3-1 front panel of WellGate 3232s
LED
Description
Power
When AC power cable is connected and power switch is
ON, the LED will light up green.
Status
When the gateway is powered ON and is operated
normally, this LED keeps steady ON.
Ready
If one of 32 ports FXS isn’t registered successfully to a
Proxy, this LED will Flash.
Flash: At least one of 32 ports FXS doesn’t register
successfully.
ON: All FXS ports are registered successfully.
OFF: Peer to Peer mode or not configure properly.
WAN 10/100
speed, ACT
This will light up green when the gateway’s WAN port is
physically connected to the public internet. When data is
transmitted through this port, it will flash green.
The default IP of WAN port is 10.1.1.3.
LAN 10/100
speed, ACT
This will light up green when the gateway’s LAN port is
physically connected to a local network. When data is
transmitted through this port, it will flash green.
The default IP of LAN port is 192.168.123.123.
1 to 32
The status LED for FXS port 1-32. It will light up when the
connected phone is in busy, or when the connected phone
is engaged in a conversation. It will flash when there is an
