24
© Well Straler all rights reserved
6
First use
The appliance has been provided with a heat-resistant coating. During the first hours of use,
it is normal for an odour to occur as this coating is burnt off. This is harmless. Allow the
appliance to burn for several hours and ventilate the area well to eliminate the odour as
quickly as possible.
Following a long period of disuse (summer months), clean the appliance of
accumulated dust to prevent a nasty odour from occurring during the first hours of reuse.
7
Operating your appliance
7.1
Pairing of remote control and receiver
Ensure that batteries are in the remote control and the receiver is powered on.
The remote control supplied with your appliance was already programmed at the
factory.
The synchronization is a one-time setting. It is not required after installing new
batteries in the remote control or the receiver.
The receiver must be paired with the remote control. Synchronisation between the receiver
and the remote control must be performed only on initial use.
1.
Press and hold the receiver's reset key (see photo below) until you hear two beeps.
2.
Release the reset key after hearing a second, longer beep.
3.
Within the next 20 seconds, press the button on the remote control.
Two short beeps will confirm that the code is set. "
" will appear on the remote control
to confirm that the synchronisation has been performed (see photo below). At the end of
this synchronisation, the current status of the gas fireplace is displayed on the remote
control.
Remote control
Receiver