USING RSCRIBE
Page | 46
ECG Collection Using the Acquisition Module
ECG acquisition can be performed at the WAM or AM12 acquisition modules. Refer to the AM12 short-form
instruction card when using the AM12.
NOTE: The WAM must be synchronized to the UTK before RScribe operation. The Universal
Transmitter/receiver Key (UTK) is a bidirectional device that links the PC’s USB port to the WAM.
Select the
ECG
button
on the WAM™ or the AM12™ to capture the last 10-seconds of acquired ECG.
Connecting the Acquisition Module
The AM12 connects to a USB port on the PC for signal acquisition. The RScribe will automatically detect the
AM12 once it’s connected to the USB port.
The WAM communicates via the UTK (Universal Transmitter/receiver Key) connected to an active USB port on the
PC. The WAM is synchronized with the UTK making them a matched pair. Using the same UTK and WAM that
were last paired maintains their synchronization.
Pairing WAM with RScribe
Start the RScribe application. Navigate to the real-time display and:
Select the settings icon
in the upper right corner of the real-time display
Select
WAM Pairing
Place the WAM (powered off) in close proximity to the UTK receiver connected to an RScribe USB port.
Select
Start
and then
Yes
Power the WAM on
.
A successfully paired message will display.
Select
DONE
.
NOTE: The wireless acquisition module (WAM) must be paired to a specific RScribe prior to signal
acquisition.
NOTE: If both AM12 and the UTK are connected simultaneously, RScribe will default to the AM12 over
the UTK with WAM for acquisition.
NOTE: Disconnecting the UTK and connecting the AM12 will automatically cause the RScribe to switch
to the AM12. It is not necessary to pair the same WAM with the same UTK to use it again.