Welch Allyn Connex IWS, Directions For Use Manual

Page: 46 / 266

4. With one hand, pull lightly on the paper to take up any slack. With the other hand,
close the printer door by pushing it down and into place until it clicks.
Be certain that the paper does not catch in the printer door.
Connect AC power
You can use the monitor with AC or battery power (after fully charging the battery).
WARNING
Shock hazard. Inspect the AC cord for exposed copper before
touching the cord.
CAUTION During continuous monitoring, keep the monitor connected to
AC power at all times. If only battery power is available, you must remain in
the room with any patient whose vital signs are being monitored
continuously. Actively monitor both patient and battery status to ensure
patient safety.
1. Insert the power cord into the AC power connector port on the back of the monitor.
2. Insert the power plug into an electrical outlet to power the monitor and to charge the
battery.
Disconnect AC power
Carefully grasp the power plug and disconnect it from the power outlet. To avoid
damaging the power cord, do not pull on the cord itself.
40 Setup Welch Allyn Connex
®
Devices