120
eikon e1s
Service and repair guide
Removing / fitting the casing
Requirements and tools
Check that the following requirements have been met:
•
The appliance has been disconnected from the power supply and protective measures have been taken to ensure
the power cannot be switched on again.
•
The appliance is cool.
•
The top, left and right panels of the casing of the appliance have been removed.
•
The high voltage capacitors are discharged before commencing work.
•
Anti-static precautions have been taken.
Tools required:
•
M5.5 hex socket wrench / nut runner
1.
Remove the top panel first. Unscrew the four remaining M5.5 screws, then
lift the rear of the panel and slide backwards.
Important note:
The high voltage capacitor should be discharged once the
top cover has been removed.
2.
To remove the side panels, unscrew the two screws that attach each side
panel to the rear panel.
When removing the side panels, lift and move the rear of the panels away
from the appliance before sliding backwards.
3.
To remove the rear panel, first unscrew the three screws at the bottom of the
panel and then the two screws either side of the air duct grille.
The panel can then be lifted to remove.
Summary of Contents for Merrychef eikon e1s
Page 11: ...11 eikon e1s Service and repair guide Section 1 Safety ...
Page 43: ...43 eikon e1s Service and repair guide Section 2 Operations and Installation ...
Page 82: ...82 eikon e1s Service and repair guide Section 3 Service and Repair ...
Page 147: ...147 eikon e1s Service and Repair Guide Circuit diagrams ...
