9. Other information
– General
105204
– WTS-300-E - V4.1 - 20.01.2022
Page 125
9.9 I/O Expansion module ESIO
With I/O extension modules, WELBA controllers can be extended with additional
digital and analogue inputs or outputs.
- The 6 output relays can be operated either all with 24V DC or all with 230V AC.
- The 5 digital inputs (24V DC) can be configured via jumper as NPN or PNP
inputs. The inputs 1..4 can additionally measure a frequency up to 10 kHz.
- The 2 current inputs 4..20mA with supply voltage connection can be used for
the connection of corresponding sensors
For proper installation, please pay attention to the
Configuration:
Assignment of relays 1 to 6
=> Parameters [A15..A20]
Assignment of digital inputs 1 to 5
=> Parameters [A29..A33]
Activation I/O extension module
=> Parameters [A74]
9.10 USB module ESUSB
The USB module ESUSB-001 is used to read out stored data from Welba controllers
that can be read out with the Welba KONSOFT configuration software (e.g. WTS-
300 or TW-31/-32).
The USB module is connected directly to the 'RS485 PC' interface of the control unit.
For proper installation, please pay attention to the
