5. Operation
105466
– TW-31-E - V1.9 - 06.04.2021
Page 25
5.2 The configuration software KONSOFT
The user-
friendly configuration software “KONSOFT" for the TW-31 can be used for
- configuration
- parameter setting
- visualisation
- storage
- updating
Configuration
All setting parameters can be entered and stored, with reference to levels, on your
PC using a clearly designed template. A description is available for every parameter.
Once all parameters are entered the complete configuration can be transferred to
the control unit via USB interface
Visualisation
Also by USB transfer, values and status or error reports can be obtained from the
control unit, displayed on screen graphically or in tabular form, and stored. This al-
lows rapid analysis in the event of a fault.
Bootloader function
This allows control units to be updated to any new software by pressing a button
without changing parameter settings.
NOTE: The KONSOFT PC-Software has been thoroughly tested and has proven itself hundreds of times in customer
use. Despite all care, we point out that the use of the free PC-Software is at your own risk. WELBA does not accept any
liability for damages or loss of data resulting from the installation or use of the Software.
5.3 Reading out the tank guard LOG file
Proceed as follows:
Insert a standard USB stick (FAT-32) into the USB socket of the tank monitor:
- The blue "DATA" LED begins to look slowly after a short time =>
The tank monitor LOG file is transferred to the USB stick!
Depending on the evaluation period [parameter h90], this transfer can take
several minutes.
- Has the data transfer been completed without faults:
The blue "DATA" LED lights up permanently for approx. 5 seconds and then
goes out.
- If the data transfer is faulty:
The blue "DATA" LED flashes quickly for approx. 5 seconds and then goes
out.
Try again or use a different USB stick.
If the LED has gone out: remove the USB stick and close the cover cap tightly.
For software descrip-
tion see separate in-
structions
NOTICE
