Page of 11
8
To add oil to the hydraulic pump:
Note:
Refer to the
Parts Breakdown
to identify parts named below.
1. Remove the pull spring to separate the workbench from hydraulic pump.
2. Use a 6mm inner hex wrench to remove the two cap screws that hold the hydraulic pump to the
base.
3. Position the pump horizontally and remove the round rubber oil plug on the back of the pump
housing.
4. Add hydraulic oil until the cylinder is approximately 3/4 full. (Oil weight is approximately
0.7kg/1.543lbs)
5. Replace the rubber oil plug and re-assemble the log splitter.
