Weinmann MANUVAC, Description And Instructions For Use

Page: 11 / 24

Use EN
11
4.3 After aspiration
1. After completing the aspiration, empty the se-
cretion bottle and rinse it, together with the se-
cretion cap and the suction hoses with clear
water on the spot.
2. Then replace the secretion cap so that the trian-
gular mark points to the upper middle line of the
secretion bottle, then fit the hoses together.
Important
Unless absolutely unavoidable, the vacuum pump
should never be transported with a full secretion
bottle, since the aspirated liquid could run out.
3. Tightly wind the connecting hose in the direction
of the arrow around the bottom of the secretion
bottle and return the bottle to the holding clip.
4. Place the thick suction hose in the housing
groove, depress the pedal and secure it with the
retaining clip.