上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
47
/
53
for how to load a program file.
2.
Optional:
Modify unrecognized tool numbers in the ENG file:
1.
Press
↑
or
↓
to select the target tool, and press
F1
.
2.
Input the target tool number, press
F7
to confirm the setting and return
to
Modify Tool No. in ENG File
dialog box.
3.
To exit from the dialog box, press
F7
.
Select Tool for ENG/G File
dialog
box pops up.
3.
To add the target tools for machining, press
↑
/
↓
→
F1
repeatedly until all
target tools are added.
If the same tool appears several times in different lines of the program file,
e.g. T1, the system automatically sorts it according to its order in the program
file, e.g. T1-1, T1-2, T1-3…You can select the target sorting to machine desired
parts.
It is default to select all tools if no tools is added.
Note:
If the version of the loaded ENG file is less than 5.50, each time you can only select one tool
for machining.
4.
To save the setting, press
F7
.
After selecting the tools, if you need to select a tool again, press
→
1
→
F4
in
Auto
mode to enter into
Select Tool for ENG/G File
dialog box, and select the
target tool.
3.6
Execute Selective Machining
This operation is used for an optional skip of the program file, by customizing the
start line and end line line of the program block, so that you can freely select the
machining range.
To execute selective machining, do the following:
1.
To enter into
Coor
interface, in
Auto
mode, press
→
1
.
