WEIHONG LS6000M, Manual

Page: 55 / 121

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
.
52 / 116
o
Description: Available in velocity control mode. The value is generated after
servo drive calibration.
o
Range: -255
–255
o
Value: 0

Part Touching Delay (Positioning)
o
Description: Indicates the part touching delay during positioning.
o
Range: 0 ms
–20000 ms
o
Value: 300

Part Touching Delay (Follow-up)
o
Description: Indicates the part touching delay during following.
o
Range: 0 ms
–20000 ms
o
Value: 500

Part Touching Delay (Punch)
o
Description: Indicates the part touching delay during piercing.
o
Range: 0 ms
–20000 ms
o
Value: 600

Enable Anti-collision
o
Description: After this parameter is enabled, if the system detects during dry
running that the cutter may have a collision, the cutter will be lifted
automatically.
o
Range

Yes: enable

No: disable
o
Value: Yes

Speed Gain
o
Description: Available in velocity control mode. Its value equals to the motor
rated power divided by 10V. It matches the motor velocity speed command
input gain.
o
Range: 10
–2000
o
Value: 300

Cutting Head Alarm Tolerance
o
Description: Indicates the capacitance change threshold that triggers the
cutter exception alarm.
o
Range: 100 Hz
–100000 Hz
o
Value: 500

Cutting Head Alarm Additional Tolerance
o
Description: The capacitance change threshold that triggers the cutter
exception alarm will equal Cutting Head Alarm Tolerance plus Cutting
Head Alarm Additional Tolerance if Capacitor Compensation is enabled.
o
Range: 100 Hz
–100000 Hz
o
Value: 1500

Capacitor Compensation
o
Description: Indicates whether to enable capacitance compensation.
o
Range

Yes: Enable

No: Disable
o
Value: No
4.3.4 Calibrate Setting
Includes the following parameters: