It refers to the maximum angle deviation between snapping and template. If actual
deviation exceeds this value, shooting may fail.
3.
Click
Apply
to activate parameter settings and click
OK
.
Measuring Distance and Angles
Use
Measure
function to measure the distance or angle between two specified
points.
Steps
1.
Move the machine axes to one point, and click
Measure 1
.
2.
Move the machine axes to another point, and click
Measure 2
.
The system will calculate the results.
Note that the angle refers to the angle relative to the positive
direction of X-axis.
Preparing Toolpath
At present, CCD system supports two kinds of working modes:
•
General engraving mode
No marking points or shooting points are needed. The system is used as a
general engraving control system.
•
Machining with marking points
–
Retrieving toolpath from a
.jpg
file
–
Importing toolpath from a
.dxf
file
Retrieving Contour from JPG File
By setting related parameters, the control system can automatically retrieve contour
from a JPG file.
Do the following to retrieve contour from a JPG file.
Steps
1.
Launch
NcStudio
, and switch to
NcEditor
interface.
2.
Click
File
→
Import JPG file…
. A dialog box named
Open
opens.
3.
Select the target
.jpg
file. A dialog box named
Contour Param
opens.
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
- 20 -
