27
Manual maxGUARD
2526740000/02/03.2018
4 Configuration
| Example configurations
4.9
Example configurations
Example: One segment without connection to a control unit
Example: maxGUARD station without connection to a control unit
This example shows a control voltage distributor for four se-
lectively fused load circuits without connection to a control
unit.
The following maxGUARD products are used:
–
1x AMG FIM-0
–
1x AMG ELM-Q2222
–
1x AMG XMD
–
1x AMG EP
–
2x WEW 35/2
–
1x ZQV 4N/6 RD
–
1x ZQV 4N/7 BL
The passive feed-in module feeds in the supply voltage. The
potentials are distributed to individual modules via uncut
cross-connectors (white markings). As the total current flow
-
ing through the station is less than 20 A, the main strands
are each equipped with only one cross-connector.
The station must be equipped with an end plate at the right
end. Only then will the exposed side of the last potential dis-
tribution terminal be covered.
