Weidmüller 1243790000, Original Operating Instructions, Page: 44 / 342

Cleaning and maintaining the machine
2518100000/03/06.2017 44
► Press the tool unit backwards and swing it to the right.
1
L, LS LZ
2
1
2
Figure 7.5 Stripping unit
► Clean the area around the hole ( 1 ) with a brush.
► If necessary, use a soft cloth and some spirit.
► Check the blade ( 2 ). If necessary, replace the blades
(see section 8.3).
7.9 Servicing the crimping tool
To reach the crimping tool, you must dismantle the strand-
ed wire fixing unit.
► Ensure that the stranded wire fixing unit is located in the
front position (figure 7.4, B ).
► Remove the bottom right screw of the stranded wire fix -
ing unit (figure 7.4, 4 ).
► Pull out the stranded wire fixing unit carefully, forwards.
For Crimpfix L: Ensure that the spacer ring stays on the
axis.
► Tilt the stranded wire fixing unit to the side and place it
down carefully.
Figure 7.6 Detached stranded wire fixing unit
Weekly (only L PZ3 and LS PZ3):
Figure 7.7 Removing PZ3 crimp dies
► Remove the fixing screw of each crimp die (2.5 mm Al -
len key).
► Pull the crimp dies up and out.