Setup
70
1449820000/1.4/04.17
Install EPLAN Electric P8 Addon
This function is not required for the Print
Jet
ADVANCED
.
Close
You close the start screen with the [Close] button.
To set the correct print position for a MultiCard and to compensate for physical changes to it, you must make
some settings via the M-Print® PRO software.
These tasks are described in detail in chapter "5 Operation”, in section “5.2 Software settings”.
If you make these settings at just one PC, for example client PC 1, then you must also make them available
to client PC 2 to client PC N. With the following function you can share these settings with the other client
PCs automatically.
1
Start the M-Print® PRO program.
2
In M-Print® PRO choose Tools and then Options.
The following window appears:
Figure 78
Clients
– sharing print settings
3
Click the [Share Print Settings] button.
The next time the users start up their PCs they are notified of the settings that have been made and can
decide whether they want to adopt them or not.
4
Next you have to activate the M-
Print® PRO software (see “4.15 Activating M-Print® PRO”).
