ASSEMBLY
2
49
8
40
49
13
12
33
40
13
12
36
22
8
36
1
1.
Before assembling this product, be sure that
you have read and understand the information
in the box above.
Press a 50mm Square Outer Cap (40) onto each
side of the Stabilizer (33).
Attach the Stabilizer (33) to the Bench Frame (49)
with two M8 x 68mm Bolts (8), two M8 Washers
(13) and two M8 Nylon Locknuts (12).
2.
Press a 50mm Square Inner Cap (36) into each end
of the Front Leg (22).
Attach the Front Leg (22) to the Bench Frame (49)
with two M8 x 68mm Bolts (8), two M8 Washers
(13) and two M8 Nylon Locknuts (12).
Before beginning assembly, carefully read the
following information and instructions:
•
Assembly requires two people.
•
Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
•
Tighten all parts as you assemble them, unless
instructed to do otherwise.
•
For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART attached at the center of the manual.
•
As you assemble the weight bench, be sure that
all parts are oriented as shown in the drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) rubber mallet
• One (1) standard screwdriver
• One (1) phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
6
