10
14. Insert a Weight Rest (37) into each Rear Upright
(19).
Be sure that the Weight Rests are inserted
at the same level on both sides.
15. Slide a Front Upright (18) onto the indicated M8 x
58mm Carriage Bolts (6) in either section of the
Base (20, 55).
A second person must hold the
Upright at the location shown during the step.
Partially tighten an M8 Nylon Locknut (12) onto
each Carriage Bolt
but do not fully tighten the
Nylon Locknut. Note: The heads of the Carriage
Bolts must lock into the square holes in each
section of the Base in order to tighten the Nylon
Locknuts; you may need to slide your fingers
under the Base to hold the Carriage Bolts in
place while you partially tighten the Nylon
Locknuts.
Assemble the other Front Upright (18) in the same
manner.
16. Press two 60mm Square Bushings (53) into a
Weight Carriage (52). Press a 1” Round Inner Cap
(41) into the Weight Carriage.
Assemble the other Weight Carriage (52) in the
same manner.
Press a 60mm Square Bushing (53) into the
Carriage Stop (54).
The drilled hole in the Square
Bushing must be aligned with the drilled hole in
the Carriage Stop.
14
15
37
37
19
19
18
18
6
6
12
12
20
55
A second person
must hold each
Upright here while
the Nylon Locknuts
are attached
16
54
41
Align
these
holes
53
52
53
53
