Weichai America Corp.
Revision: August 2019 67
⑨
Press lower bearing shell and lower thrust plate (the side with oil groove should face
crankshaft) into crankcase and assemble the crankshaft.
⑩
Apply clean lubricating oil on crankcase bolt bearing surface and main bearing bolt
thread. Place main bearing bolts and pre-tighten them according to the order shown in
Figure below. Firstly pre-tighten to 70Nm, and then tighten each bolt for another 90°±4°.
Assembly of crank shaft is finished.
Fig. 11- 10 Tighten order of main bearing bolts
11.6.4 Inspection and maintenance of crankshaft system
①
Check whether there is crack on fillet area of crankshaft main journal and neck of crankshaft;
Check the joint part of crankshaft and main bearing for crack, check and dredge the oil gallery.
②
Check the wear condition of crankshaft main journal and neck of crankshaft, and check whether
there is line-like puckering, metal peeling and crack.
③
Check the wear condition of front and rear oil seals.
④
Check whether there is failure like thread damage on main bearing bolts
⑤
Check crankshaft flange bolt holes for crack.
⑥
Check wear condition of crankshaft journal, check bend and distortion condition of crankshaft.
WEICHAI & PSI SERVICE MANUALS AVAILABLE ONLINE AT FLYPARTSGUY.COM
GET YOUR WEICHAI & AFTERMARKET SERVICE PARTS AT FLYPARTSGUY.COM