9. INSPECTION | MAINTENANCE
Please note:
Subsequent mentions of descriptions and position numbers refer to
Chapter 3. Product overview / product description on page 10
Attention:
If damage to the WEH
®
Product, restrictions to its functionality or leaks are
found, the WEH
®
Product must be sent to WEH for maintenance.
9�1
Safety instructions for inspection and maintenance
- The WEH
®
Product must be depressurized and dismantled for maintenance work.
Î
Check the WEH
®
Product for leakage after maintenance work. Please refer to
- For inspection purposes, it is not necessary for the WEH
®
Product to be dismantled,
but it must be depressurized.
Î
Only use original WEH
®
Spare parts. These are exactly suited to the intended applica-
tion and subject to strict quality controls.
Î
Do not damage sealing surfaces or sealing components.
Î
Before reassembling; check the components, threads and, if present, the sealing
surfaces for damage and contamination. Should you find any damage, replace the
WEH
®
Product or send it to WEH for maintenance. Stop using the WEH
®
Product
immediately.
Î
Assemble the WEH
®
Spare parts absolutely free of oil, grease and dust.
Î
Before each reassembly, clean the WEH
®
Product and the corresponding
components by blowing off with oil-free compressed air and remove any adhering
dirt using a damp, soft and lint-free cloth.
Do not use solvents. Use only clean water as cleaning agent.
Attention:
Only use oil-free compressed air to blow off the dirt.
Note:
Make sure that no cleaning agent enters the gas channel.
Î
Observe the specified tightening torques during maintenance.
Î
Clean the wire filter insert (Pos. 3) using only commercially available neutral cleaning
agents and detergents. Please also note:
- Because the main body of the filter is made of brass, the cleaning agent must not
contain ammonia.
- No aggressive substances may be used that could attack the materials in the filter.
- The cleaning agent must leave no residue on the wire mesh filter as this would compro-
mise the flow rate of the medium when the device is put back into operation.
MD-10012-L51-R1.1.0-03
Page 17
Operating instructions
AE
Summary of Contents for TSF4
Page 2: ......
