Wegener DTV742, User Manual

Page: 15 / 50

DTV 742 User’s Manual
wegener.com 15 800057-01 Rev. B
Rack
Mounting Your DTV742 is sized to fit in an EIA-standard, 19-inch-wide equipment rack.
a) First install angle brackets or cross-supports capable of supporting both
the unit and its connecting cables. Screw or bolt the supports securely
to the equipment rack.
b) Place the DTV742 on its supports and use four anchor screws or bolts
and nuts to secure the unit’s front brackets to the rack.
c) Connect the chassis grounding screw to an earth ground before
connecting the power cord to the unit.
WARNING
The front brackets must be secured to the rack. If front brackets are left
unsecured, the unit may shift forward and fall from the rack during installation
or operation. Failure to secure the front brackets may result in personal injury
and/or damage to the equipment.
WARNING
Locate the DTV742 and its cables to avoid impacts, spills, and pulling cables
and to ensure sufficient air flow. Failure to locate the DTV742 in a proper
environment may result in damage to the equipment.