Wega Wegaconcept, Use And Maintenance Manual

Page: 43 / 76

43
Wegaconcept
Technical manual
ENGLISH
i
In the even you want to program the stand by
periods, and/or rest periods of the machine, set
the time to 00:00.
28.9 Configuration of groups proper use
To configure proper use of the single delivery groups,
proceed as follows:
ENTER
(x 5 secs.)
Hold down the ENTER button for at least 5 seconds.
Scroll the menu until the item is highlighted
05 ENERGYSAVE TIMING
06 WORKING MODE
07 STBY MODE
08 AUTOSTEAMER MODE
ENTER Confirm to access the menu
SET ON/STBY/OFF
GR.1 XXX
Set the operating mode of group 1: ON always active,
STBY, config. stand-by, OFF always inactive
Confirm and go to next group Repeat the operation for
each delivery group.
Once the last group has been set, the display will show
the Energy Saving settings
SET ON/ESAV/OFF
REST XXX
Set the machine stand-by mode: ON machine always
on, ESAV set on Energy Saving, OFF completely turned
off.
Confirm and move to the next screen.
REDUCED SETPOINT
STBY TEMP. XXX.C
Set the temperature of the groups in the stand-by
phase
Confirm and go to programming of the temperature of
the entire machine in the energy saving phase (only if
set)
Time of the second stand-by period of the delivery groups:
STANDBY 2 TIME
FROM HR:MN
Set the start time for stand-by. To switch from hours
(HR) to minutes (MN) press the (
) key.
Once the minutes (MN) are set, press ( ).
STANDBY 2 TIME
TO HR:MN
Set the start time for stand-by. To switch from hours
(HR) to minutes (MN) press the (
) key.
Once the minutes (MN) are set, press ( ).
Programming the energy saving time of the machine.
Time of activation of machine Energy Saving
REST TIME
HR:MN
Set the start time for stand-by. To switch from hours
(HR) to minutes (MN) press the (
) key.
ENTER Confirm to exit the menu.
05 ENERGYSAVE TIMING
06 WORKING MODE
07 STBY MODE
08 AUTOSTEAMER MODE
To exit the programming menu