WEG CVW-300, Assembling Manual, Page: 7 / 20

Signal Conectors Kit KCS-300
E
ng
lis
h
CVW300 | 7
8.9 N to be sure of the retention fingers are holding
the contact.
Retention fingers
holding contact
Pull back
on wire
(a) (b)
(c)
3. After all required contacts have been inserted, the
wedge lock must be closed to its locked position.
Releasing the locking latches by squeezing them
inward.
Squeeze locking latches to
seat wedge lock (both slides)
4. Slide the wedge lock into the housing until it is flush
with the housing.
Wedge lock flush
with housing
5 DISASSEMBLY PROCEDURE
The plug must be disassembled (contacts removed)
as it follows:
1. Insert a 4.8 mm wide screwdriver blade between the
mating seal and one of the red wedge lock tabs.
2. Pry open the wedge lock to the open (as shipped)
position.
3. While rotating the wire back and forth over a half turn
(one-quarter turn in each direction), gently pull the
wire until the contact is removed.
Wedge
lock tab
For further details about the conectors, please refer
to www.te.com.