WEG CFW500 V1.8X, Programming Manual, Page: 94 / 172

VVW Vector Control
10-10 | CFW500
10
Seq Action/Indication on the Display Seq Action/Indication on the Display
9 10
„
If necessary, modify the content of “P0401 – Motor Rated
Current”, or press the
key for the next parameter.
„
If necessary, modify the content of “P0402 – Motor Rated
Speed”, or press the
key for the next parameter.
11 12
„
If necessary, modify the content of “P0403 – Motor Rated
Frequency”, or press the
key for the next parameter.
„
If necessary, modify the content of “P0404 – Motor Rated
Power”, or press the
key for the next parameter.
13 14
„
If necessary, modify the content of “P0407 – Motor Rated
Power Factor”, or press the
key for the next parameter.
„
At this point, the HMI shows the option to do the Self-tuning .
Whenever possible, execute the Self-tuning. To activate the
Self-tuning, change the value of P0408 to “1”.
15 16
„
During the self-tuning, the HMI will simultaneously indicate
the “
RUN ” and “ CONF ” status. And the bar indicates the
operation progress.
„
At the end of the Self-tuning the value of P0408 automatically
return to “0”, as well as the “
RUN ” and “ CONF ” status are
erased.
„
Press the key for the next parameter.
17 18
„
The result of the Self-Tuning is the value in ohms of the stator
resistance shown in P0409. This is the last parameter of
the Self-Tuning of the V V W control mode. Pressing the
key returns to the initial parameter P0202.
„
To exit the STARTUP menu, just press BACK/ESC .
19
„
By means of the and keys, select the desired menu
or press
BACK/ESC
again to return directly to the HMI
monitoring mode.
Figure 10.2: Start-up of the VVW mode