HMI and Basic Programming
4-2 | CFW300
4
Start-up Mode
It is the initial status of the HMI after the successful power-up (without fault,
alarms or undervoltages).
Press the
key to go to level 1 of the setting mode - parameter selection.
Pressing any other key will also change to the setting mode.
Monitoring
Setting
Level 1
Setting
Level 2
Setting Mode
Level 1:
This is the first level of the setting mode. The number of the parameter is shown
on the main display.
Use the
and
keys to find the desired parameter.
Press the
key to go to level 2 of the setting mode - modification of the
parameter content.
Level 2:
The content of the parameter is shown on the main display.
Use the
and
keys to configure the new value for the selected parameter.
Press the
key to confirm the modification (save the new value). After the
change is confirmed, the HMI returns to level 1 of the setting mode.
Figure 4.3:
HMI operating modes
NOTE!
When the inverter is in the fault state, the main display indicates the number of the fault in the format
Fxxx
. The browsing is allowed after pressing the key.
NOTE!
When the inverter is in the alarm state, the main display indicates the number of the alarm in the format
Axxx
. The browsing is allowed after pressing the key, and then the indication
"A"
is displayed on
the unit of measurement display, flashing until the situation causing the alarm is solved.
Summary of Contents for CFW300 V1.3X
