WEG CFW-11 Series, Programming Manual, Page: 212 / 307

Digital and Analog Inputs and Outputs
13-30
13
Description:
They define the origin of the Speed Reference in the LOCAL situation and in the REMOTE situation.
Some notes about the options for those parameters:
The AIx’ designation refers to the analog signal obtained after the addition of the AIx input to the offset and its
multiplication by the applied gain (refer to the Item 13.1.1 Analog Inputs [38] on page 13-1 ).
The value of the reference adjusted with the and is contained in the parameter P0121.
When the option 7 is selected (E.P.), one of the digital inputs must be programmed at 11 (Increase E.P.) and another
at 12 (Decrease E.P.). Refer to the Section 12.5 ELECTRONIC POTENTIOMETER [37] on page 12-9 , for more
details.
When the option 8 is selected, P0266 and/or P0267 and/or P0268 must be programmed at 13 (Multispeed).
Refer to the Section 12.4 MULTISPEED [36] on page 12-7 .
When P0203 = 1 (PID Regulator), do not use the reference via E.P.
When P0203 = 1, the value programmed in P0221/P022 becomes the PID Setpoint.
P0223 – FORWARD/REVERSE Selection - LOCAL Situation
P0226 – FORWARD/REVERSE Selection - REMOTE Situation
Adjustable
Range: 0 = Always FORWARD
1 = Always REVERSE
2 = Forward/Reverse Key (FWD)
3 = Forward/Reverse Key (REV)
4 = DIx
5 = Serial/USB (FWD)
6 = Serial/USB (REV)
7 = Anybus-CC (FWD)
8 = Anybus-CC (REV)
9 = CANopen/DeviceNet/Profibus DP (FWD)
10 = CANopen/DeviceNet/Profibus (REV)
11 = AI4 Polarity
12 = SoftPLC (FWD)
13 = SoftPLC (REV)
14 = AI2 Polarity
15 = PLC11 FORWARD
16 = PLC11 REVERSE Factory
Setting: P0223 = 2
P0226 = 4
Properties: CFG, V/f, VVW and Vector
Access groups
via HMI: 01 PARAMETER GROUPS or 01 PARAMETER GROUPS
31 Local Command 32 Remote Command
Description:
They define the origin of the "Speed Direction" command in the LOCAL situation and in the REMOTE situation,
where:
FWD: Means Forward Default situation.
REV: Means Reverse Default situation.
DIx: Refer to the Item 13.1.3 Digital Inputs [40] on page 13-12 .