WebGate C1080PBL-IR48-AF, User Manual

Page: 1 / 68

1
Caution for installation and usage
1. Precautions for different DVR
Please use it with the corresponding PoC DVR. With PoC(Power over Coax) function, the
DVR is able to supply camera with the power. And with CoC(Control over Coax) function,
the DVR is able to send RS485 to the camera
- PoC DVR : When connecting to WEBGATE’s PoC DVR, only the coaxial cable is needed
between the camera and DVR to supply power and send RS485.
- Non PoC DVR : When connecting to Non PoC DVR, the user must use repeater, RP101P,
to connect to the camera (but RP101P needs additional adapter)
2. Check Frame rate setting based on power frequency
- Set Frame rate to 25Hz if your region is using 50Hz(PAL) power frequency, or set to 30Hz
for 60Hz(NTSC) region. (OSD : System

Frame rate).
3. Focus setup
To aviod losing focus at night time, please adjust camera focus as follows.
1) Open the camera cover, and connect the OSD remote controller to the camera.
2) Press [SET] on the OSD remote controller and select “FOCUS ADJ” to enable “Adjust
Focusing” mode.
3) Use the lens’ lever to adjust zoom and focus. (※Check the Focus Gauge)
4) End the “Adjust Focusing” mode by pressing the [SET] on the OSD remote controller.
※ What is Focus Gauge?
When the user is manually adjusting the focus, the camera shows graphical bar to have
the user look at the focus visually. When the yellow and green bar meets together,
that’s where the camera is focused.
4. Shutter mode setup based on installation environment
- INDOOR : Controls brightness for the best video quality at indoor environment.
- OUTDOOR : Controls brightness for the best video quality at outdoor environment.
- INDOOR/OUTDOOR-ANTI BLUR : Improves the motion blurring phenomenon than
Indoor/Outdoor mode under dark environment but the brightness decreases relatively.
5. Please contact to qualified service personnel in case of product damage. Do not
attempt to repair product by yourself.
6. Please avoid external shock and vibration on the product.
7. Do not install product under excessive heat or cold environment. (recommended
operation temperature is -10°C~50°C)
8. Do not target lens to the sun. Image sensor might be damaged
9. Do not open the product under any circumstances, it could void the warranty. Natural
disaster like lightning, flood will need charge for repair.
En
gl
ish