Weber Markoprint XB4JET, Manual For Installation, Operation And Maintenance, Page: 125 / 162

Appendix 72800153 Markoprint XB4JET / XB8JET
Seite 125 von 162 GB
Software update
A software update of the controller is carried out as follows:
To perform a software update a USB-Stick with the newest software version is needed.
Following folder must be copied to the USB-Stick:
HMI, HTML+, HTML und System .
1. Switch on system and keep the Start button pressed until the lowest LED is blinking green
/ red.
2. Connect the USB-Stick with the newest version and wait until the lowest LED is blinking
green / yellow.
3. With a short press on the Start button the version will be copied and the system restarts.
Wait until the top and the lowest LED is red.
4. With again a short press on the Start button the HMI files will be copied and the system
restarts.
5. Wait until the LEDs are stable and then disconnect the USB-Stick.
6. Done.
Software upgrade
A software upgrade with costs is comfortably possible via the Weber Marking Partner
Portal.
Please contact your consultant or local distributor to get a software-upgrade.
You can find a detailed instruction of the software upgrade below the search key
„Configuration upgrade“ in the Wiki of the Weber Marking Partner Portal.