19
Adjust the desired work height of the guide bar with the set
screw (position 3, figure 4).
Open the vandalism flap (position 1, figure 4).
Insert the vandalism flap (1) into the designated holder on
the valve box (position 2, figure 4).
Bring the gas lever into the full-throttle position “ON”.
Turn the ignition key to position “2” and hold it until the
engine turns over.
Release the ignition key as soon as the engine is running.
ATTENTION! Danger of material damage from running
electric starter.
The ignition key must spring back to position “1”
automatically. Otherwise, shut down the machine
immediately.
Set the gas lever to the idle speed “STOP”.
The operational status indicator signals that the machine
is ready for operation.
ATTENTION
Risk of engine damage if start procedures take too long.
One start procedure must not be longer than 5 seconds. Pause
for at least 10 seconds before repeating the start procedure.
WARNING
Danger of suffocation from engine exhausts when starting the
engine in closed rooms or poorly ventilated work areas.
Start the engine only in well-ventilated environments.
See section “Safety” for operating the machine in trenches.
ATTENTION
Risk of engine damage. The use of starter spray may lead to
overheating in the combustion chamber.
Do not use any starter spray.
Working with the machine
Starting the engine
CR 6 Hd E & CR 6 Hd CCD
Summary of Contents for 0116538
Page 1: ...CR 6 Hd CR 6 Hd E CR 6 Hd CCD 0116538 0116539 0116540 Operating and Maintenance Manual...
Page 30: ...30...
Page 31: ...31...
