SECTION 11: I
NLET
H
OOD
23
SECTION 11: INLET HOOD
Inlet hoods are shipped
u
nassembled and m
u
st be assembled prior to installation. The inlet hood may be
installed either onto the inlet of the air handler or to an o
u
tside
w
all. After installing an inlet hood, all hard
w
are
m
u
st be torq
u
ed according to recommended specifications on
. In addition, all seams m
u
st
be ca
u
lked (pro
v
ided by others).
NOTE:
Check to be s
u
re that all req
u
ired components are present. If any are missing, contact yo
u
r
WEATHER-RITE
™
independent distrib
u
tor.
11.1 Inlet Hood Assembly
FIGURE 12: Inlet Hood with Filter Racks
Crush Hazard
Use proper lifting
equipment and
practices.
Falling Hazard
Use proper safety
equipment and prac-
tices to avoid falling.
Severe Injury Hazard
Use proper lifting
practices and equip-
ment.
Equipment and
accessories are
heavy.
Cut/Pinch Hazard
Wear protective gear
during installation,
operation and
service.
Edges are sharp.
WARNING
Failure to follow these instructions can result in death, injury or property damage.
Top Roof
Top Rain Gutter X2
Top Left
Bottom Left
Bottom Rain
Gutter X2
Bottom
Filter Rail
X8
Bottom
Right
Top
Right
Bottom
Roof
Summary of Contents for XT112
