STEP 4
Install the rear leg, with the tie down facing the outside
using (1) Part C, (1) Part L, and (1) Part F.
The outside plate will have the Weather Guard® logo.
STEP 6
Repeat steps 3 - 5 for the passenger side.
STEP 7
STEP 5
Install the front leg to the driver side arm assembly by
sliding the leg guide tube over the lower tube while
making sure the plate is on the outside of the assembly
and the c-channel and gusset are on the inside of
the assembly. Loosely secure the front leg using the
leg clamp bracket with (2) Part D, (2) Part L, and
(2) Part F. Loosely install set screws (Part P).
Loosely install legs to the plates that attach to the front and rear
side members to make installation of the Cross Member easier.
INSTALLATION TIP:
REAR LEG
FRONT DRIVER’S
SIDE LEG
LEG CLAMP
BRACKET
FRONT DRIVER’S
SIDE ARM
REAR DRIVER’S SIDE
ASSEMBLY
CENTER CROSS MEMBER
Install center cross member, the cross member without
the Weather Guard® logo, to one of the front legs using
(2) Part C, (2) Part L, and (2) Part F.
Tilt the assembly up and balance the assembly on
the legs while installing to the opposite front leg
using (2) Part C, (2) Part L, and (2) Part F.
4
©2019 WernerCo