Operation manual 20997-Duftdos-UNPL (09/16)
Page 3 von 9
2.
Saftey
2.1
Technical safety advice
Company WDT does not take the liability for damages that occur due to not considering this manual. The easy and safe operation of the unit
assumes a correct transport, storage and installation of the unit. Respect the following advices to minimize the risk in injury or even serious
injury or danger for life.
Attention
The installation of the unit has to be done in accordance with the local safety norms (e.g. for Germany DIN/ VDE)
and all other relevant governmental norms and laws.
During the operation all covers of the unit have to be closed. Disconnect unit components from power supply prior
to maintenance or repair work and secure against reconnection.
Danger
Please note the information in these operating and installation instructions about dangers, warnings and
precautions.
General
Obey all safety notes and warnings present on the unit.
In case of a malfunction, switch off the unit immediately and prevent a restart. Repair malfunctions immediately.
After any repair work, have qualified personnel check the safe operation of the unit. Use original spare parts only.
Additional national safety regulations also fully apply to the operation of this unit.
Always use original spare parts!
Accident Prevention Regulations
Comply with the accident prevention regulation
Accident Prevention Regulation Electrical Systems and Equipment (VBG4/BGVA2) must be observed to prevent
injury to yourself and others.
Operation of the Unit
Do not perform any work which compromises the safety of the unit.
Regularly check that all safety and monitoring devices are functioning normally.
Do not remove or disable safety devices.
Installation, Disassembly, Maintenance and Repair of the Unit
Attention:
Work on the electrical system may only be performed by suitably trained personnel.
Disconnect unit components from power supply prior to maintenance or repair work.
Attaching or installing
additional components
is permitted only with the
consent
of the manufacturer.
In case of faults in the power supply switch off the device immediately.
Use only original fuses with the appropriate amperage rating.
Disposal after De-installation
Note:
The operator is responsible for the disposal of unit components as required by law.