LPR assembly Removal & Replacement
•
Remove the back plate
using a suitable 2mm
Allen key.
•
Remove the LPR chamber end plug
using
a suitable 4mm Allen key.
•
Remove the right hand grip cheek cover
by removing the 3 retaining screws using
a 2mm Allen key.
•
Remove the top plate retaining screw
and slide
the top plate backwards to remove.
•
Unplug the solenoid plug
from the PCB and
carefully feed it through the guide hole in the
Angel body. Ensure that the solenoid load
spreader
does not cover the exhaust ports.
•
Remove the Angel eyes ribbon cable connectors
from the ZIFF socket on the circuit board.
•
Remove the 2 grip frame retaining screws
using a 3mm Allen key.
•
Remove the LPR retaining pin
.
•
Insert the LPR piston extracting tool
0
into the
piston
and withdraw slowly.
•
Remove the 3 tri active piston spring stack
.
•
Remove the shims
.
•
Remove the piston spacer
•
Using a suitable blunt pick, carefully withdraw
the LPR body
.
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted
to the ANGEL.
· Ensure the hopper is removed from
the ANGEL.
· Ensure that there are no paintballs
in the ANGEL.
· Always remove the first stage regulator and
release all residual gas pressure from the
Angel before disassembly.
· The Angel can hold a small residual gas
charge, typically two shots, with the first stage
regulator removed. Always discharge the Angel
in a safe direction to relieve this residual gas
pressure.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU
MUST SEEK EXPERT ADVICE.
0
PLAN VIEW
SHOWING
SOLENOID
PLUG GUIDE
HOLE AND
GASKET
ORIENTATION
NOTE: THE NUMBER OF SHIMS MAY
VARY FROM NUMBER SHOWN IN DIAGRAM.
SPRING
STACK
ORDER
NOTE: WHEN RECONNECTING THE EYE RIBBONS TO THE PCB
THE SHORTER RIBBON CONNECTS TO TOP ZIFF SOCKET.
