The Angel uses a visible dual optical eye (break
beam) system to detect when a ball is in position
ready to fire.
The eyes are located under the eye ribbon cover
.
•
Remove Macroline from Fore Grip
.
•
Remove Fore Grip Cap
.
•
Remove the mini reg spool
as per the in line
regulator service instructions (see page 20).
•
Remove the fore grip body internal retaining
screw
using a 4mm Allen key and the
fore grip itself
.
•
Ensure that the fore grip body seal
is not lost.
•
Remove the volume chamber maintenance plug
with a 4mm Allen key.
•
To remove the eye cover
, slide a blunt blade
beneath the ‘A icon’ on the left side of the eye
cover (ensuring you do not insert the blade too far)
to lever out and retain the arm open. Repeat the
same procedure on the right arm. Slide the cover
towards the front and off the Angel.
•
Carefully extract each eye
from its location and
clean the eye and location hole if required.
Important Notes for re assembly: The Angel eyes
sensor MUST NOT be pulled out of the body by
the ribbon cable; the sensor MUST be Pushed out
using a suitable blunt pick from within the body.
Angel eyes servicing
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted
to the ANGEL.
· Ensure the hopper is removed from
the ANGEL.
· Ensure that there are no paintballs
in the ANGEL.
· Always remove the first stage regulator and
release all residual gas pressure from the
Angel before disassembly.
· The Angel can hold a small residual gas
charge, typically two shots, with the first stage
regulator removed. Always discharge the Angel
in a safe direction to relieve this residual gas
pressure.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU
MUST SEEK EXPERT ADVICE.
