1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Mini Nucleus
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reported
within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
V092120 subject to change.
specifications
Step 1:
• Place one of the open base cabinets w/ adj. shelves
(A)
and one
of the base cabinets w/ door
(B)
upside down on a protected
flat surface with it’s sub-bottoms facing up. (
Upon installer’s
discretion, remove door & shelving before turning cabinets
over to lessen the weight of the cabinets.
)
• When you’re placing cabinets
(A)
&
(B)
down on the protected
surface, align the pre-drilled holes on the side of cabinet
(A)
to
the pre-drilled holes on the back of cabinet
(B)
.
Step 2:
• With cabinets
(A)
&
(B)
aligned together, place the 1/4-20 x 30mm
joint connector bolt w/ loctite through pre-drilled hole on the
inside of one of the cabinets making sure bolt is pushed as far as
it can go.
• While holding the joint connector bolt flush to the cabinet, take
a 1/4-20x17mm joint connector nut and attach it to the end of the
bolt (located in other base cabinet) turning it clockwise until it’s
completely on. Use a 4mm Allen wrench or 4mm Hex bit and a
screw gun to tighten as needed.
• Repeat
Step 2
with the other Joint connector bolt and nut.
Step 3:
• Repeat
Step 1-2
to attach the other base cabinet w/ door
(C)
&
the base cabinet w/ adj. shelves
(D)
.
Step 4:
• Using image to the right as an example, slide cabinets
(A)
&
(B)
to cabinets
(C)
&
(D)
making sure you are aligning the pre-
drilled holes on each of the cabinets together.
• Once pre-drilled holes are aligned, place the 1/4-20 x 30mm joint
connector bolt w/ loctite through pre-drilled hole on the inside
of one of the cabinets making sure bolt is pushed as far as it can
go.
• While holding the joint connector bolt flush to the cabinet, take
a 1/4-20x17mm joint connector nut and attach it to the end of the
bolt (located in other base cabinet) turning it clockwise until it’s
completely on. Use a 4mm Allen wrench or 4mm Hex bit and a
screw gun to tighten as needed.
• Repeat
Step 4
to attach the other set of cabinets.
NOTE:
There will be two bolts/ nuts to connect cabinets (A) to (C)
and then another two bolts/ nuts to connect cabinets (B) to (D).
Step
1-2
Step
3
Step
4
A
B
Cabinet
A
: Unit with Adj. Shelves
Cabinet
B
: Unit with Door
Cabinet
C
: Unit with Door
Cabinet
D
: Unit with Adj. Shelves
C
D
D
A
B
C