1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reported
within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
EPIC Ingenuity Table
Assembly Instructions
Step 1:
• Place the EPIC frame leg with plate facing down on a
protected flat surface.
Step 2:
• Align holes in the end plate of the cross bar with the
frame. Make sure the tabs on the cross bar are facing
down.
• Connect cross bar to the frame using 1/4”-20 x 50mm joint
connector bolts and 1/4”-20 joint connector nuts.
• Use a screw gun and a 4mm Hex bit to tighten the joint
connector bolts to the nut. We suggest using a 4mm Hex
wrench to hold the nut in place while tightening the bolt.
• Repeat for other frame leg.
Step 3:
• Place the EPIC Ingenuity top face down on a protected
flat surface so threaded inserts and pre-drilled pilot holes
are facing up.
Step 4:
• Place frame leg/cross bar on the top and align with
threaded inserts & pre-drilled pilot holes.
• Using a screw gun and a 4mm Hex bit, secure both frame
legs to top with 1/4”-20 x 15mm joint connector bolts. Use
eight bolts for each frame leg.
Step 5:
• Using a screw gun and a # S2 square bit, secure cross bar
to top with #10 x 3/4” square pan screws. Use one screw
per tab with a total of six screws being used (3 per side).
EPIC frame leg
Step
1
Step
2
Cross bar
Tab
Joint connector bolt
Joint connector nut
V022821 subject to change.
EP3082-FXO-RR6
Step
3
Step
4
Step
5
