Waygate Technologies Krautkramer USM 100, Operating Manual, Page: 169 / 330

Defining the probe angle 5 Operation
Krautkrämer USM 100 Rev. 9 (09/2023) 169
5.18 Defining the probe angle
The function group Probe Angle provides all functions
to define the current index angle of a probe on a refer-
ence block. The current probe index angle is influenced,
e.g. by different materials or by the wear of the probe
contact face.
ATTENTION
You have to carry out calibration (see from
page 165) before defining the probe angle.
– After calibration, select the function group Probe An-
gle (see page 156).
– Select Block and choose the used calibration block.
– Check the values of SDH Diameter and SDH Depth
and correct them if necessary.
– Couple the probe to the calibration block.
– Position the gate on the calibration echo.
– In the Command bar tap on Calibrate (see page 74)
to execute the calculation.
The calculated angle is briefly displayed in the informa-
tion line at the bottom edge of the display screen.