Waygate Technologies Krautkramer USM 100, Operating Manual, Page: 133 / 330

Material Probe 5 Operation
Krautkrämer USM 100 Rev. 9 (09/2023) 133
Frequency
With this function you can set the frequency of your
probe.
The frequency is set automatically when you select a
probe by its number or name (see page 132).
Probe Delay
This is the same function as in the function group
A-Scan (see page 126).
Probe Angle
With this function you can adjust the angle of incidence
of your probe for the test material. This value is required
for the automatic calculation of flaw position.
The probe angle is set automatically when you select a
probe by its number or name (see page 132).
Probe X-Value
With this function you can set the X value (distance of
probe front edge from the probe index or sound exit
point) of the connected probe.
This value is required for the automatic calculation of the
reduced projection distance.
Effective Diameter
With this function you can set the effective transducer
diameter of the connected probe.
The effective diameter is set automatically when you se-
lect a probe by its number or name (see page 132).