[45]
SETUP COMMAND
You may program the WaveWare SPS5 v9 Series Paging Systems to monitor for interference using
the Carrier Detect mode. If the Carrier Detect mode is turned “ON”, the paging encoder will hold paging
messages in queue until an offending carrier signal is no longer detected at the transmission frequency of the
paging encoder. The settings programmed by the Setup command will be remembered by the paging system
even if power is removed from the paging system.
The Setup command is formatted as follows:
<SOH>S,X,V<EOT>
S
indicates Setup Mode,
X
is the command type, and
V
is the value. The comma delimiters are optional.
Valid values (
X
) are:
1 = CARRIER DETECT MODE
Valid values (
V
) are:
0 = OFF 1 = ON
EXAMPLE 1:
<SOH>S,1,0<EOT>
Sets the Carrier Detect function to the “Off” status.
EXAMPLE 2:
<SOH>S11<EOT>
Sets the Carrier Detect function to the “On” status.
STATUS COMMAND
You may request the paging encoder to respond with its programmed settings using the Status command.
THE STATUS COMMAND IS FORMATTED AS FOLLOWS:
<SOH>S?<EOT>
Where the
S?
Requests the paging encoder to respond with the status of its current programmed settings.
The Status Command can be used in supervisory controlled applications to ensure the encoder is still
functioning, without causing unwanted paging transmissions.
