Wavetek ANT-20, Operating Manual

Page: 74 / 126

Broadband Analyzer/Generator ANT-20/ANT-20E
A-10 Application Guide
2.3.3 Configuring the Test Type: “ATM Test Control” VI
To configure the test type required for your measurement task
✓
The “Test Setup” dialog window is open.
⇒
Click the “Configure Test” button.
The “Test Setup <...>” dialog window opens.
Fig. A-15 The “Test Setup - ATM Layer Qos (SVC) - Calling” dialog
A) To assign virtual channels to your test type
✓
The first index card for “Channel A” has been selected
1. In the “Select channel” list, mark the virtual channel that you want
to assign to the
first
test channel:
e.g. with the designation “CBR_Voice” (constant bit rate voice traffic).
The corresponding parameter values are shown on the index card.
2. Click on the index card for the second channel, e.g. “Channel B”.
The index card moves to the front.
3. In the “Select channel” list, select the virtual channel that you want to assign to the second
test channel e.g. with the designation “CBR_Data” (constant bit rate data traffic).
The corresponding parameter values are shown on the index card.
Fig. A-16 Assigning virtual channels to your test type
Note:
•
The “Select channel” list contains just a few standard channels when it is first opened.
•
Virtual channels can be used more than once, i.e. on more than one index card.
C
B
A
1.
2.
3.